During changeovers, production teams lose time hunting for the right hardware and validating it against drawings. Even when the part is “close enough,” the verification step pulls attention away from throughput and increases the risk of mixed lots on the floor.
In this line, fasteners were delivered as station-ready kits: labeled by assembly step, matched to the torque and joint requirements, and packaged to reduce handling. The goal wasn’t just convenience—it was repeatability across shifts and faster onboarding for new operators.
With kitted hardware, the team reduced the number of decision points on the line. The result was smoother changeovers, fewer interruptions for verification, and less variation in installation quality from one run to the next.